Look at the indent around the opening. On the shorter can it goes from wide to narrow at the back of the tab. It’s more of a straight line on the taller can

If I still worked where I used to I 100% would. No cans around me now :(

I guess I’m a bit rusty, so I am not sure at 355ml and the skinny profile if you can get a 202 end can, or have to use a 200

Hard to tell if it’s sleek or slim

Edit: Actually no, that’s a 200 not a 202. Look at the profile around the tab.

They do, but overall the can end (lid) is a LOT more aluminum than you expect and the whole rest of it isn’t as much as you expect.

So a little less lid is worth a fair bit more sidewall in terms of weight of aluminum

It’s definitely more surface area per volume, but a 200 vs 202 lid and a smaller hermetic seal cancels some of those losses. Sidewall is cheap aluminum wise, but you’re likely right in that it’s a little more aluminum. Definitely costs more to make since they do fill a little slower.

Also fuck coke, what a bunch of assholes

That looks like a 202 vs a 200 can end, so a “sleek” not a “slim” (red bull can is slim)

The sleek can is 355 ml and uses a 200 end.

As for which uses more aluminum… Good question. It’s probably close